FAG H309 Adapter Sleeve - 40 mm ID, 65 mm OD, 39 mm Width System24 Designed to drill and tap

Designed to drill and tap in one operation

It allows you to loosen any component that is mounted on a shaft and is freely accessible from the outside

The set of Pulling jaws extensions is used to extend the reach

They accommodate angular misalignment between connected components and are available in male and female thread variants

FAG H309 Adapter Sleeve - 40 mm ID, 65 mm OD, 39 mm Width System24 Designed to drill and tapAdapter Sleeve FAG adapter sleeves enable a tapered bore bearing to be mounted on a cylindrical shaft. They provide a frictional fit between bearing and shaft and are used together with a lock nut and lock washer.